FAQs
Select one of the categories to find the desired
I. Problems:
The flour mill produces flour at too high a temperature
Solution:
Should be appropriate to loosen the clearance of the grinding rollers, such as the cause of wear and tear of the grinding rollers, should be repaired or replaced in time; summer should be especially pay attention to, pay attention to the heat dissipation of the flour mill.
II,
Problems: flour mill in the normal production of less powder or no powder
Solution: it is likely that the sieve mesh is blocked, clean up the sieve mesh or replace the new mesh.
Three,
Problems: the flour mill works normally, but the output has dropped
Solution: Adjust the gap between the grinding rollers, press the spring to ensure that the gap between the two ends of the grinding rollers is consistent. It is also possible that the grinding teeth are used for a long time, caused by serious wear and tear, and should be re-drawn.
Four,
Problems: wheat flour mill such as shaking phenomenon
Solution: The fixing screws should be checked and the coupling bolts between the mill head and the frame should be tightened. Check the solid condition with the ground angle screws.
Five,
Problems: flour mill only out of flour, not out of bran
Solution: The common reasons are the main shaft steering is not right, the sieve mesh is broken or the sieve frame is not sealed tightly.
What are the methods of unloader inspection and maintenance? The layout of the unloader is careful, long application life, but the unloader in some cases of improper device or material is not suitable will form the unloader motor fault, then the formation of motor fault causes and how to prepare for it is necessary to understand, so that later you can prevent the reappearance of similar failures.
(1) unloader check the surrounding environment will affect the motor heat dissipation consequences of the formation of motor destruction
(2) unloader selection is not right the amount of material unloaded is too large, greater than its own unloading capacity, long time overload things to extend the application of the life of the motor
(3) the viscosity of the material unloaded by the unloader is too high motor pressure is too large to form a destruction
(4) unloader motor wiring is solid. The above four situations are prone to form the unloader motor dust fault, affecting the normal things of the unloader, so customers must pay attention to the application or device purchasing.
1. Do maintenance work every day, start and shut down the machine, check, there is no damage to the equipment.
2. Regularly on the unloader above the dust, to carry out a clear gray work.
3. Regular replacement, regular inspection, good ventilation.
4. unloader speed, as far as possible, do not so fast, do not let him overloaded.
HOW CAN WE HELP ?
Get In Touch With Us!
Contact Information
Fax: +86-371-23227333
E-mail: global@aomgmach.com
Production base: Zongdian Industrial Zone, Qi County, Kaifeng City